This is BIGTREETECH BTT Manta M5P Control Board.
BIGTREETECH Manta M5P adopts 32Bit 64MHZ ARM Cortex-M0+Series-STM32G0B1RET6 chip, can also run Marlin without CB1/CM4.support 5 axis stepper motor driver, Integrated SPI and UART mode of TMC driver and DIAG pin, easily configurable with jumpers. It supports CAN Bus/Filament runout sensor, BLTouch, RGB etc. Onboard SPI interface and proximity switch port for connecting acceleration sensor to enable Klipper’s input shaping.
BIGTREETECH Manta M5P Control Board reserves proximity switch interface and SPI expansion interface, supports NPN and PNP type selection, (24,12V, 5V) voltage selection and for users use Klipper firmware to connect external acceleration sensor for acceleration compensation. The new E-FUSE fuse is equipped, which can respond quickly, enhance self-protection ability, and greatly reduce the motherboard burnout caused by short circuits or ignition.
Note: Raspberry Pi Board and CB1 are not included. Refer to Manual in the ATTACHMENTS section for more info. regd. the product.
Features:
- Added eFuse circuit protection. It will faster disconnected on overload, and automatically reset if the overload is gone, which will greatly reduce the motherboard burnout caused by short circuits or ignition.
- Reserved Can Bus port can be connected with EBB CAN, which will simplify the wiring and provide strong  anti-interference ability
- These are born for Klipper running designed with the same connector BTB as Raspberry Pi, giving you a confident connection with all version of CM4 ,and definitely CB1. a screw rein forced installation is available too.
- Integrated SPI and UART mode of TMC driver and DIAG pin, easily configurable with jumpers.
- Support filament runout sensor, BLTouch, RGB, etc.
- Replaceable fuse for easy maintenance.
Package Includes:
1 x BIGTREETECH Manta M5P Control Board
1 x Type C USB Cable and accessories
There are no reviews yet.